The motorcycle may be started without keys with a special procedure using the dashboard and the switches on the handlebar.
Note
This procedure is only possible if the pin code has been enabled previously. For security reasons, the pin code is disabled by default when the vehicle leaves the factory.
To switch on the dashboards without having the key and start the procedure with the pin code (provided that the pin code is active) it is necessary to press once the on/off button on the hands free system.
Once vehicle speed exceeds 5 km/h after starting the motorcycle with the pin code, the no key message is displayed on the dashboard. This is normal.
After switching both the engine and the dashboards off, the pin code entry procedure has to be repeated in order to use the motorcycle again.
How to enable engine start with pin code
See the paragraph relevant to the dashboard for entering and using the pin codeimmobilizer override procedure in sect.
6 - 7.
How to enable the pin code
See the paragraph relevant to the dashboard for enabling the pin codeimmobilizer override procedure in sect. 6 - 7.
Recovery procedure in the event of hands free system fault
How to reset the pin codeEngine
Twin cylinder, four-stroke, 90 "l" type, longitudinal, with
deep sump die-cast crankcase.
Bore, mm: 106
Stroke, mm:
67.9
Total displacement, cu. Cm:
1198
Compression ratio:
11.5В±0.5:1
Max power at crankshaft (95/1/ec), kw/hp:
119 kw/162 hp at 9,500 rpm
Max torque at crankshaf ...
Refitting the handlebar
Position the handlebar (4) so that the external lower corner of the marks (a)
on the handlebar matches the upper internal
corner of the lower u-bolts (b) as shown.
Apply the recommended grease to the threads and undersides of the heads of
the screws (3).
Important
Position the upper u-bo ...
Refitting the silencer
Position the silencer guard (41) and fix it by starting the screws (40).
Tighten the screws (40) to a torque of 8 nm +/- 10% (sect. 3 - 3, Frame torque
settings).
Insert the silencer (4) into the central exhaust pipe (26), and fix it to the
vehicle by starting the screw (1).
Hold the ...