Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Indicator cons. Avg - average fuel consumption

Ducati Diavel Service Manual / Electric system and engine control system / Instruments / Indicator cons. Avg - average fuel consumption

This function indicates the "average" fuel consumption.

The calculation is made considering the quantity of fuel used and the km travelled since the last trip 1 reset. When trip 1 is reset, the value is set to zero and the first available value is shown on the display 10 seconds after the reset. Dashes "- -.-" Are shown on the display during the first 10 seconds when the value is not yet available.

The datum is expressed in "l / 100" (litres / 100 km); it is possible to change the units of measurement for "consumption" (both average and instantaneous together) from l/100 to km/l through the "units of measurement modification function" function of the setting menu.

The active calculation phase occurs when the engine is running and the vehicle is stopped (moments when the vehicle is not moving and the engine is off are not considered).

Indicator cons. Avg - average fuel consumption


Distance travelled on fuel reserve: trip fuel
This function shows the distance travelled on fuel reserve (in km or miles depending on the specific application). When the fuel light comes on, the display automatically switches to the "trip ...

Indicator cons. - Instantaneous fuel consumption
This function indicates the "instantaneous" fuel consumption. The calculation is made considering the quantity of fuel used and the distance travelled during the last second. The datum is expres ...

Other materials:

Separation of the crankcase halves
Use two screwdrivers to remove the circlip (29) from the timing belt driveshaft shaft (30) on the clutch-side crankcase half. Note Take care to avoid scoring the surface of the shaft while removing the circlip. Unscrew the crankcase half screws on the chain side. Unscrew ...

Removal of the swingarm
Before removing the parts in question, you must first carry out the following operations: Remove the rear wheel eccentric hub as described in chapter "removal of the rear wheel eccentric hub and rear wheel shaft" of this section. Loosen screws (7) and remove the hose grommets (13), (15) ...

Disassembling the water radiator unit
The procedure is the same for both radiators. Loosen the screws (15), (21) and (25) to remove the air duct (24) from the right radiator (13). Undo the screws (12) and (14) to remove the half-fairing (23) from the radiator. Radiator inspection Visually inspect the oil co ...

2026 | www.dudiavel.com |