Ducati Diavel Owners Manual: Limited liability
- The liability of ducati under this emission control systems
warranty is limited solely to the remedying of defects in
material or workmanship by an authorized ducati motorcycle
dealer at its place of business during customary business
hours. This warranty does not cover inconvenience or loss of
use of the motorcycle or transportation of the motorcycle to
or from the ducati dealer. Ducati shall not be liable for any
other expenses, loss or damage, whether direct, incidental,
consequential or exemplary arising in connection with the
sale or use of or inability to use the ducati motorcycle for any
purpose. Some states do not allow the exclusion or limitation Of any
incidental or consequential damages, so the above
limitations may not apply to you.
- No express emission control system warranty is given by
ducati except as specifically set forth herein. Any emission
control system warranty implied by law, including any
warranty of merchantability or fitness for a particular
purpose, is limited to the express emission control systems
warranty terms stated in this warranty. The foregoing
statements of warranty are exclusive and in lieu of all other
remedies. Some states do not allow limitations on how long
an implied warranty lasts so the above limitation may not
apply to you.
- No dealer is authorized to modify this ducati limited
emission control systems warranty.
This emission control system warranty shall not cover any
of the following:
Repair or replacement required as a result of
Accident,
Misuse,
Repairs improperly performed or replacements ...
This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.
This warranty is in addition to the ducati limited
motorcycle warranty.
Additional ...
Other materials:
Key-on/key-off using the red key on the handlebar with the passive key
A key-on can be performed by pressing the red button (6) on
the handlebar in the hands free on/off position and in
the presence of the passive key (4, fig. 77).
Note
The passive key (4, fig. 77) Has a range of a few cm,
therefore the key (4, fig. 77) Must be positioned near the
antenna (2). R ...
Reassembling the electrical components support
Check the presence of clips (1), (9) and (24) on the support (5).
Check the presence of rubber pads (6) and (8) and of cable grommet (7).
Check that the voltage regulator (3) and the solenoid starter (18) are in
place on the support (5) with their wiring as
shown.
The horn (22) mus ...
Replacing the high and low beam bulbs
Before replacing a burnt-out bulb, make sure that the new
bulb complies with the voltage and wattage specified in the
"wiring diagram", page 179. Always test the new bulb
before refitting any parts you have removed.
Fig. 150 Shows the locations of the low beam bulbs (lo), high
beam ...