Ducati Diavel Owners Manual: Ducati limited warranty on emission control system
Ducati north america, inc., 10443 Bandley drive cupertino, california, 95014 warrants that each new 1998 and later ducati motorcycle, that includes as standard equipment a headlight, tail-light and stoplight, and is street legal: a) is designed, built and equipped so as to conform at the time of initial retail purchase with all applicable regulations of the united states environmental protection agency, and the california air resources board; and b) is free from defects in material and workmanship which cause such motorcycle to fail to conform with applicable regulations of the united states environmental protection agency or the california air resources board for a period of use of 30,000 kilometers (18,641 miles) or 5 (five) years from the date of initial retail delivery, whichever first occurs.
California emission control warranty statement
Your warranty rights and obligations
The california air resources board is pleased to explain the
emission control system warranty on your my 2011
motorcycle. In california, new motor vehicles must ...
Coverage
Warranty defects shall be remedied during customary
business hours at any authorized ducati motorcycle dealer
located within the united states of america in compliance
with the clean air act and ap ...
Other materials:
Tail light - number plate holder
Rh tail light
Vibration damper mount
Spacer
Screw
Number plate light
Screw
Screw
Plate
Number plate holder
Nut
Screw
Rear chain guard
Lh tail light
Spring washer
Vibration damper mount
Splashguard
Screw
Spacer
Screw
Washer
Splashguard (europe - australi ...
Overhaul of the flywheel-alternator assembly
Examine the inner part of alternator rotor (24) for signs of damage. Check
that the starter clutch is working properly and
that the needle races do not show signs of wear or damage of any kind. If there
is any malfunction, remove the whole
assembly.
Disassembling the generator flywheel
U ...
Refitting the external components
Fit the cap (39) on spring (38) until it engages.
Mount ball (40), spring (38) with cap (39), washer (37) and screw (36) on the
chain side half-casing by starting the
screw into hole (f).
Note
The spring (38), with cap (39), must be oriented as shown.
Tighten the screw fully home to a torqu ...