Ducati Diavel Service Manual: Belly fairing
- Rh belly fairing
- Lh belly fairing
- Special screw
- Nylon washer
- Screw
- Central belly fairing
- Oil cooler shield
- Special screw
- Clip
- Washer
- Clip
- Screw
- Bracket
- Screw
Spare parts catalogue
Diavel abs belly fairing
Diavel carbon abs belly fairing
Important
Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.
Refitting the rear mudguard
Place the rear mudguard (8) on the swingarm, fitting the screws (9) with
recommended threadlocker.
The screw (9) in the bottom hole of the rear mudguard (8) must be installed with
the washer (r ...
Removal of belly fairing
Loosen and remove the screws (5) and (8) that secure the oil cooler (7) to
the rh (1) and lh (2) belly fairings.
Remove the lh belly fairing (2) by loosening the screws (3) with relevan ...
Other materials:
Refitting the timing covers
Locate vertical cylinder external cover (25), horizontal cylinder external
cover (3) and central external cover (1) by
starting the screws (4).
Apply the recommended threadlocker to the screws (4).
Tighten the screws (4) to a torque of 10 nm (min. 9 Nm - max. 11 Nm) (sect. 3 -
3, Engine t ...
Electrical power for lighting and signalling devices
The front and rear running lights consist of led units with light conduits.
As a result, the light source is not visible as the
light is diffused through the surface of the light conduit.
These two images illustrate the front and rear running lights with light
conduits.
The figure ...
Refitting the filler cap
Position seal (18) in tank cap (10) as shown and reassemble following the
removal procedure in the reverse sequence.
In particular tighten the screws (17) to a torque of 3 nm +/- 10% (sect. 3 - 3,
Frame torque settings).
...