Ducati Diavel Service Manual: Reassembly of the seat
Place the seat cover (2) on the seat and fix it (on the lower side) by starting screws (4) on plates (5).
Tighten the screws (4) to a torque of 4 nm +/- 10% (sect. 3 - 3, Frame torque settings).
Disassembly of the seat
Remove the seat and turn it upside down.
Loosen the special screws (4), turn the plates (5) and open the seat cover (2)
lateral sides to slide it out.
...
Refitting the seat
Note
Apply recommended grease to the hole (a) of latch (6).
Fit the seat (1) as follows: insert the tabs (b) (on the front side) under
the rubber pads (c) of the gloves compartment;
then push ...
Other materials:
Wiring diagram colour codes
B blue
Bk black
Bn brown
G green
Gr grey
Lb light blue
O orange
P pink
R red
V violet
W white
Y yellow
Rear left fuse box (1) key
Rear right fuse box (2) key
...
Refitting the evaporative emissions canister
To refit, carry out the removal operations in reverse order, making sure to
locate the hoses as shown in the figures at the
end of the chapter.
Positioning the hoses / clamps and canister filter
...
Dashboard menu option scrolling not possible
Fault codes
Dds: no fault code displayed
Dashboard: no fault code displayed
Location of connections and components
Location of left hand handlebar switchgear set connection.
Pin numbering for wiring harness side dashboard connector. ...