Ducati Diavel Owners Manual: Tool kit and accessories
The tool kit (2) is located under the seat (1) while the owner’s manual is housed in the compartment under the seat.
The tool kit includes:
- Fuse pliers;
- Two helmet anti-theft cables;
- Screwdriver;
- Screwdriver handle;
- 14/16 Mm box wrench;
- 6 Mm rod;
- 3 Mm allen wrench;
- 4 Mm allen wrench;
- 5 Mm allen wrench.
To access the underseat compartment, remove the seat (see "removal of the seat" on page 119).
Refuelling
Never overfill the tank when refuelling. The fuel level should
always be below the rim of the filler recess.
Warning
Use low-lead fuel with 95 octane rating at origin
minimum (see "top-ups&q ...
Other materials:
Adjusting the chain tension
Make the rear wheel turn until you find the position where chain is tightest.
Set the vehicle on the side stand. Push down
the chain at the point of measurement and release. Measure the distance between
the "aperture" upper profile and pin
centre.
The read distance must be: 9 to 11 mm.
...
Removal of the handlebar
Unscrew and remove the screws (3) securing the upper clamp (1).
Remove the upper clamp (1).
Remove the handlebar (4) from its seat on the steering head.
To remove the grips (5), refer to the exploded view at the beginning of this
chapter.
...
Reassembly of the crankcase halves
If removed, apply threadlocker on the screw (36), insert it with the washer
(37) on the crankcase half and tighten it to The torque of 8 nm
(min. 7 Nm - max. 9 Nm) (sect. 3 - 3, Engine torque settings).
If removed, apply threadlocker on the dowel thread (35), tighten it to a
torque of 20 ...