Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Fork

Refitting the gearchange mechanism
Make sure that the gearchange linkage assembly (6) is installed with the ball joint with a left-hand thread (a) facing the lever (8). Apply the recommended grease to the non-threaded surface of ...

Steering head: front fork
Screw Screw Steering head Bottom yoke Left fork leg assembly Right fork leg assembly Counter nut Damper assembly Bush Spring Preload tube Collar Washer Top cap assembl ...

Other materials:

Removal of the rear brake calliper
Important The brake manufacturer advises against any servicing of the internal components of brake callipers or the master cylinder. Incorrect overhaul of these critical safety components can endanger rider and passenger safety. Before removing the parts in question, you must first carry ou ...

Refitting the rear brake control
If the pushrod (18), clip (30) and fork (31) assembly has been dismantled, reassemble it by screwing the nut (29) onto the rod (18) and then screw the rod into the fork (31) to obtain the measurement indicated in the figure. Block the rod and tighten to a torque of 7.5 Nm +/- 10% (sect. 3 - ...

Removal of the rear brake disc
Remove the rear eccentric hub (sec. 7 - 13, Removal of the rear wheel eccentric hub and rear wheel shaft). Undo and remove the four fixing screws (13) of the brake disk to the wheel axle and remove the rear brake disk (14). Loosen the four screws (24) and remove the rear phonic wheel (25). ...

2026 | www.dudiavel.com |