Ducati Diavel Owners Manual: Position of motorcycle controls
- Instrument panel on handlebar.
- "Hands free" system.
- Instrument panel on tank.
- Left-hand handlebar switch.
- Clutch lever.
- Rear brake pedal.
- Right-hand handlebar switch.
- Throttle twistgrip.
- Front brake lever.
- Gear change pedal.
Controls
Warning
This section shows the position and function of the
controls used to ride the motorcycle. Be sure to read this
information carefully before you use the controls. ...
Hands free system
The hands free system consists of:
Hands free lock;
Antenna;
Active key;
Passive key;
Electric cap (optional).
The "hands free" button (7, fig. 79) Is located on tank fron ...
Other materials:
Adjusting the position of the gearchange and rear brake
pedals
The position of the gearchange and rear brake pedals in
relation to the footrests can be adjusted to suit the
requirements of the rider.
Adjust the pedals as follows:
Gear change pedal (fig. 97)
Hold the linkage (1) and slacken the lock nuts (2) and (3).
Note
Nut (2) has a left-hand thr ...
Coolant temperature
This function indicates coolant indication state.
The temperature unit of measure can be selected (C or f).
The reading is indicated as follows:
If the reading is between - 39C and +39C "lo" is
shown flashing on the instrument panel (steady);
If the reading is between +40C an ...
Absolute pressure sensors
Introduction
The engine control system of the diavel is equipped with two absolute
pressure sensors, with one connected to the intake
duct of each cylinder (map 1 cylinder 1 - horizontal - map 2 cylinder 2 -
vertical). They are used by the control unit to
determine the quantity of fuel to be ...