Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Reassembling the front footrest brackets

Ducati Diavel Service Manual / Chassis / Footrest brackets / Reassembling the front footrest brackets

To reassemble the brackets (6) and (21) carry out the removal procedure in the reverse order; tighten the screws (7) to a torque of 25 nm +/- 10% (sect. 3 - 3, Frame torque settings).

Reassembling the front footrest brackets


Reassembling the front footrest brackets


Reassembling the front footrest brackets
To remove the front rh footrest bracket (6) it is necessary to remove the rear brake master cylinder reservoir (by leaving it connected to the braking system), and the rear brake lever from the bra ...

Removing of the rear footrests
The removal of the rear footrests is described for the right side but it is the same for both. Undo the pin (13) and remove the rh rear footrest (12) from the frame. Recover washer (8) and the ...

Other materials:

Separation of the crankcase halves
Use two screwdrivers to remove the circlip (29) from the timing belt driveshaft shaft (30) on the clutch-side crankcase half. Note Take care to avoid scoring the surface of the shaft while removing the circlip. Unscrew the crankcase half screws on the chain side. Unscrew ...

Refitting the filler cap
Position seal (18) in tank cap (10) as shown and reassemble following the removal procedure in the reverse sequence. In particular tighten the screws (17) to a torque of 3 nm +/- 10% (sect. 3 - 3, Frame torque settings). ...

Removal of the gearbox assembly
Withdraw the selector fork shafts (30). Move the forks (28) and (29) to disengage them from the slots in the selector drum (14). Withdraw the selector drum (16) taking care not to lose shims (31) and (27) mounted on the shaft. Note that the positions of the shims must not be inverte ...

2026 | www.dudiavel.com |