Ducati Diavel Service Manual: Refitting the rear-view mirrors
Start the screws (2) in their thread on the rear-view mirrors (1), inserting the washers (4) as shown in the picture.
Insert the rear-view mirrors (1) in the u-bolts (3).
Tighten the screws (2) to a torque of 25 nm +/-10% (sect. 3 - 3, Frame torque settings).
Warning
The left rear-view mirror screw (2) has a left-handed threading.
Removal of the rear-view mirrors
Undo the screws (2), remove the rear-view mirrors (1) and recover the washers
(4).
...
Fairings
Rh front half-fairing
Clip
Screw
Right-hand support
Screw
Screw
Rh air inlet
Lh air inlet
Screw
Clip
Left-hand support
Lh front half-fairing
Lh tank fairing
Screw
Ny ...
Other materials:
Low hands free key (hf) battery level
The activation of this (amber yellow) "warning" indicates
that the hands free system has detected that the battery
that permits the active key (1, fig. 62) To communicate and
turn the vehicle on is almost discharged.
Note
In this case, ducati recommends replacing the battery
as soon ...
Component assembling position
The throttle valve position sensor is integrated in the throttle valve
actuator motor.
Location of electric connection for throttle valve actuator motor - tps
(throttle valve position sensor).
Connection wiring diagram
Ccm engine control connection, s throttle valve position senso ...
Dashboard
Note
The dashboard is supplied as a single component; its internal components
cannot be renewed separately.
Important
Whenever the dashboard is renewed, the ignition key programming procedure
must be repeated.
Loosen the nuts (2) to remove the master dashboard (1) from its seat and
disconn ...