Ducati Diavel Service Manual: Removal of the crankshaft/connecting rods assembly

Crankshaft/connecting rods assembly

Special screw Connecting rod assembly Half bearing Grub screw Bushes Crankshaft Grub screw Shim washer Spare parts catalogue Diavel abs connecting rods Diavel carbon abs co ...

Disassembly of the crankshaft/connecting rods assembly

Unscrew the screws (1) and separate the connecting rods from the crankshaft. Important Take care not to mix up components of different connecting rods and maintain the original orientation. ...

Other materials:

Adjusting the steering head bearings
Excessive handlebar play or shaking forks in the steering head indicate that the play in the steering head bearings requires adjustment. Proceed as follows: loosen the clamp screw (1) that holds the steering tube to the steering head. Slacken the clamp screws (2) securing the steering head ...

Low battery level
The activation of this (amber yellow) "warning" indicates that the status of the battery vehicle is low. It is activated when the battery voltage is ¼ 11.0 Volt. Note In this case, ducati recommends charging the battery as soon as possible with the specific device, as it is possible th ...

Removal of the swingarm
Before removing the parts in question, you must first carry out the following operations: Remove the rear wheel eccentric hub as described in chapter "removal of the rear wheel eccentric hub and rear wheel shaft" of this section. Loosen screws (7) and remove the hose grommets (13), (15) ...