Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Removing the silencer

Loosen the clamp (38) that retains the silencer (4) to the complete exhaust system.

Removing the silencer


While holding the nut (8), loosen the screw (1) and remove the silencer (4) from the motorcycle.

Removing the silencer


Loosen the screws (40) and remove the silencer guard (41).

Removing the silencer


Exhaust system
Screw Bush Vibration damper mount Silencer Washer Screw Bracket Nut Nut Upper heat guard Screw Washer Central heat guard Spacer Clip nut Long exhaust spring Plug ...

Removal of the exhaust system
Remove the silencer, as described in the paragraph "removing the silencer" of this section. Loosen the screws (28) and remove the exhaust by-pass valve cover (27). Turn the exhaust valve pul ...

Other materials:

Injection relay
Introduction The fuel pump, injectors and ignition coils are all powered via the injection relay. The relay also sends voltage to the engine control unit, which enables activation of the relay itself. Component assembling position A injection relay; b etv relay (throttle valve actuator mot ...

Refitting the primary drive gears and checking backlash
Fully degrease the crankshaft splined end and the corresponding spline on the primary drive gear. Position the spacer (c) onto the crankshaft. Fit the driving gear (b) onto the crankshaft with the oil pump drive sprocket facing the crankcase. Temporarily secure the gear with the was ...

Engine temperature sensor
Introduction The engine control system on the diavel uses a sensor that measures the temperature of the coolant (engine temperature). This sensor has a resistance of ntc type (negative temperature coefficient), that reduces its own value when the temperature increases. The engine temperature ...

2026 | www.dudiavel.com |