Ducati Diavel Owners Manual: Clock
This function shows the time.
Time is always displayed as follows:
Am from 0:00 to 11:59
Pm from 12:00 to 11:59
If battery power is suddenly cut off (battery off), when battery power is restored and upon next key-on, the clock is reset and restarts operating from "0:00".
Engine rpm indicator (rpm)
This function displays the rpms.
The instrument panel receives the engine rpm information
and displays it.
This information is displayed progressively from the left to
the right, identifying t ...
Coolant temperature
This function indicates coolant indication state.
The temperature unit of measure can be selected (C or f).
The reading is indicated as follows:
If the reading is between - 39C and +39C &quo ...
Other materials:
Refitting the timing belts
Rotate the pulleys on the timing belt driveshaft until the timing mark on the
outer roller is aligned with the mark on the
clutch-side crankcase cover.
In this condition, the horizontal cylinder piston will be at top dead centre.
Install in the alternator cover seat the tool code 88713.20 ...
Introduction to the engine control system
The engine control system used on the diavel consists of the following
elements:
Ride-by-wire system (motorised throttle valves with electric actuator,
throttle grip position sensor and throttle valve
position sensor)
One injector per cylinder installed downstream of throttle valve
On ...
Refitting the front forks
Refit the fork legs, positioning them at the height shown in the figure
relative to the upper surface of the bottom yoke.
Warning
The difference in height between the two fork legs must be no
greater than 0.1 Mm.
Position the fork legs (5) and (6) on the yoke base (4) and on the steering ...