Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Handlebar unit

Bleeding of the abs hydraulic system
If some "sponginess" is detected on the brake control, due to air bubbles in the system, bleed the system, as indicated in sect. 4 - 3, Changing the brake fluid. Before bleeding a brake pump, mo ...

Throttle twistgrip
Upper clamp Counterweight Screw Handlebar Grips Throttle twistgrip Bush Screw Bush Throttle cables Spare parts catalogue Diavel abs handlebar and controls Diavel carbon ...

Other materials:

Checking protection and safety device components
Checking the side stand switch Remove the switch (1) from the side stand undoing screw (2) and disconnect the main wiring connector from the switch (see paragraph "routing of wiring on frame", sect. 6 - 1). Use an analogue or digital multimeter (sect. 6 - 11, Using a multimeter to check the ...

Refitting the front brake master cylinder
Insert the front brake master cylinder unit (1) on the right side of the handlebar to bring the terminal internal edge in correspondence to the bolted joints (a). Fit the terminal (12) on the handlebar inserting the screws (15). Tighten the terminal (12) retaining screws to a torque of 10 ...

Reassembling the electrical components support
Check the presence of clips (1), (9) and (24) on the support (5). Check the presence of rubber pads (6) and (8) and of cable grommet (7). Check that the voltage regulator (3) and the solenoid starter (18) are in place on the support (5) with their wiring as shown. The horn (22) mus ...

2026 | www.dudiavel.com |