Ducati Diavel Owners Manual: Battery voltage indicator (battery)
This function describes the battery voltage indicator.
To access the function it is necessary to view the "setting" menu page 48, using
button (1, fig. 14) ?"
" or (2, fig.
14) ?"
" select the "battery" function
and press the reset
button (12, fig. 12) To confirm.
The information will be displayed as follows:
- If battery voltage is between 11.8 And 14.9 Volt the reading will be displayed steady;
- If battery voltage is between 11.0 And 11.7 Volt the reading will be displayed flashing;
- If battery voltage is between 15.0 And 16.0 Volt the reading will be displayed flashing;
- If battery voltage is equal to or less than 10.9 Volt, "low" is shown flashing and the "vehicle/engine diagnosis - eobd" light (7, fig. 4) Comes on;
- If battery voltage is equal to or greater than 16.1 Volt, "high" is shown flashing and the " vehicle/engine diagnosis - eobd" light (7, fig. 4) Comes on.
Note
Dashes "- - -" appear if the reading is not available.
Stored lap erase function
This function erases the stored laps.
To access the function it is necessary to view the "setting" menu page 48, using
button (1, fig. 14) ?"" or (2, fig.
14) ?"" ...
Clock setting function
This function sets the clock.
To access the function it is necessary to view the "setting" menu page 48, using
button (1, fig. 14) ?"
"or (2, fig. 14) ?""select th ...
Other materials:
Refitting the gearchange mechanism
Make sure that the gearchange linkage assembly (6) is installed with the ball
joint with a left-hand thread (a) facing the
lever (8).
Apply the recommended grease to the non-threaded surface of the pin (4).
Fit the first o-ring (5) in the pin (4).
Start the pin (4) in the gearchange leve ...
Information about the model
Identification data
Diavel identification data
Each ducati motorcycle has two identification numbers -the frame number and
the engine number- and an ec nameplate
(a) (not present on the us version).
Note
Please quote these numbers, which identify the motorcycle model, when
ordering spare pa ...
Cylinder compression test
Note
The on-screen icons used during this procedure are explained in a table at
the end of this section.
Engine performance is directly correlated to the pressure that can be
measured in the combustion chambers of the two
cylinders. Pressure which is too high/low or an excessive difference be ...