Ducati Diavel Service Manual: Fuel tank
- fuel tank
- Rubber pad
- Spacer
- Screw
- Hose
- Tray
- Y-fitting
- Hose
- Hose
- Filler cap
- Screw
- Complete hose guide
- Screw
- Hose clip
- Hose
- Screw
- Screw
- Sealing washer
- Screw
- Flange
- Sealing washer
Spare parts catalogue
Diavel abs fuel tank
Diavel abs fuel system
Diavel carbon abs fuel tank
Diavel carbon abs fuel system
Important
Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.
- Removal of the fuel tank
- Removal of the fuel tank filler cap
- Refitting the filler cap
- Replacing the tank flange and fuel sensor
- Refitting the fuel tank flange
- Refitting the fuel tank
Removal of the fuel tank
On the usa version remove the canister filter as indicated in sect. 8 - 10,
"Removal of the evaporative emissions
canister".
Loosen and remove the front retaining screw (4)
Remove the f ...
Other materials:
Refitting the camshafts
If the stud bolts (2) were removed, apply the recommended threadlocker to the
short end of the stud bolts (2), i.E. The
end that is to be screwed into the cylinder head. Tighten the stud bolts (2) to
a torque of 10 nm (min. 9 Nm - max. 11
Nm) (sect. 3 - 3, Engine torque settings).
Check t ...
Replacing the high and low beam bulbs
Before replacing a burnt-out bulb, make sure that the new
bulb complies with the voltage and wattage specified in the
"wiring diagram", page 179. Always test the new bulb
before refitting any parts you have removed.
Fig. 150 Shows the locations of the low beam bulbs (lo), high
beam ...
Starter motor
Power:
0.7 Kw/12 v
Direction of rotation:
counter clockwise viewed from power take-off side.
The starter motor is highly compact and reliable and therefore rarely gives
any type of problem. In case of troubles,
ensure that the starter motor cable terminal is properly tightened under the n ...