Ducati Diavel Service Manual: Abs components maintenance

Flexible wiring/hoses positioning

The routing of the abs wiring has been optimised to ensure the minimum obstruction. Each section is designed to prevent interference with parts that might damage wires or cause operating failur ...

Adjusting of the air-gap phonic wheel sensor

(For front as well as rear sensor) in each case of maintenance that foresees: Replacement or refitting of the wheel Replacement or refitting of the phonic wheel (1) or (2) Replacement or refit ...

Other materials:

Refitting the timing belt driveshaft pulleys
To fit the circlip (10) in the driveshaft seat, use the tool code 88713.2834. Install the inner spacer (17) on the driveshaft, taking care to align the notch in the spacer with the slot for the woodruff key. Fit the first woodruff key (16) on the timing belt driveshaft. Locate the ...

Changing the clutch fluid
Warning Clutch fluid will damage painted surfaces if spilled on them. It is also very harmful if it comes into contact with the skin or with the eyes; in the event of accidental contact wash the affected area with abundant running water. Remove cover (1) and membrane from the clutch fluid res ...

Refitting the rear wheel eccentric hub and rear wheel shaft
Refitting is the reverse of removal, with attention to the following points. If the calliper bracket locating pin (14) was removed, apply the recommended threadlocker on reassembly. Tighten the pin (14) to the torque of 33 nm +/- 5% (sect. 3 - 3, Frame torque settings). If previously ...