Ducati Diavel Owners Manual: Hands free system
The hands free system consists of:
- Hands free lock;
- Antenna;
- Active key;
- Passive key;
- Electric cap (optional).
The "hands free" button (7, fig. 79) Is located on tank front end.
- Hands free system key-on and key-off
- Key-on/key-off using the red key on the handlebar with the active key
- Key-on/key-off using the key on the hands free lock with the active key
- Key-on/key-off using the red key on the handlebar with the passive key
- Key-on/key-off using the key on the hands free lock with the passive key
- Key-on/key-off using the pin code (immobilizer release)
- Entering pin code function for vehicle release
Position of motorcycle controls
Instrument panel on handlebar.
"Hands free" system.
Instrument panel on tank.
Left-hand handlebar switch.
Clutch lever.
Rear brake pedal.
Right-hand handlebar switch.
Th ...
Hands free system key-on and key-off
Key-on consists in turning on the hands free system and all
of its electronic devices.
Key-off consists in turning off the hands free system and all
electronic devices, and makes sure the engine ...
Other materials:
Refitting the abs control unit
If the brake hoses (7), (8), (9) and (10) on the abs control unit are changed
or removed, ensure that the fittings on the
control unit are positioned correctly.
Warning
If incorrectly positioned, the hose can affect brake operation and
foul moving parts. Position the hose as shown in the
fig ...
Checking and adjusting the valve clearances
Note
For clarity, the figures show the engine removed from the frame.
Move the piston of the cylinder being checked to tdc of the power stroke: in
this condition, all the valves are closed and
the timing shafts come in neutral position and, therefore, free to rotate; check
to the valve cl ...
Refitting the rear brake control
If the pushrod (18), clip (30) and fork (31) assembly has been dismantled,
reassemble it by screwing the nut (29) onto
the rod (18) and then screw the rod into the fork (31) to obtain the measurement
indicated in the figure.
Block the rod and tighten to a torque of 7.5 Nm +/- 10% (sect. 3 - ...