Ducati Diavel Service Manual: Cylinder head assemblies

Refitting the water pump

Clean the seat on the cover, any parts you intend to reuse, and the impeller shaft. Then refit as follows. Fit on the impeller (10) shaft the mechanical seal (9) as indicated in the figure. ...

Checks and adjustments

Closing shim Intake side camshaft Opening shim Exhaust side camshaft Valve Spare parts catalogue Diavel abs cylinder head: timing system Diavel abs vertical cylinder head Diavel a ...

Other materials:

Refitting the flywheel-alternator assembly
Fit the roller cage unit (20) with washer (18) and internal ring (19), applying prescribed grease on the washer (18). Install the roller cage assembly (20) with the washer (18) and inner race (19). Install the flywheel assembly (v) with the gear (21), aligning the notches as shown in ...

Reassembly of the control unit
Insert the control unit (4) into the protecting sheath (5) and position it on the airbox. Position the relay supporting bracket (2) by starting and tightening the screws (1) to a torque of 6 nm +/- 10% (sect. 3 - 3, Frame torque settings), and connect the control unit connectors (3). ...

Traction control (dtc) deactivated
The activation of this (amber yellow) "warning" indicates that dtc (ducati traction control) has been turned off. Note In this case, ducati recommends being very careful when riding as the vehicle behaviour will be different in comparison to when operating with the traction control ...