Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Flywheel - alternator

Ducati Diavel Service Manual / Engine / Flywheel - alternator

Flywheel - alternator


  1. Screw
  2. Alternator stator
  3. Plug
  4. Sealing ring
  5. O-ring
  6. Cover
  7. Screw
  8. Aluminium gasket
  9. Screw
  10. Bracket
  11. Locating bush
  12. Screw
  13. generator cover
  14. Flange
  15. Flanged nut
  16. Plane washer
  17. Flywheel
  18. Washer
  19. Inner ring
  20. Needle roller bearing
  21. Electric starter driven gear
  22. Starter clutch
  23. Circlip
  24. Alternator rotor
  25. Screw
  26. screw
  27. Bearing

Spare parts catalogue

Diavel abs water pump-altr-side crankcase cover

Diavel abs electric starting and ignition

Diavel abs connecting rods

Diavel carbon abs water pump-altr-side crankcase cover

Diavel carbon abs electric starting and ignition

Diavel carbon abs connecting rods

Important

Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.

Reassembly of the gearbox
To refit the gearbox components follow the procedure under sect. 9 - 9.2, Reassembly of the crankcase halves, relating to reassembly of the engine crankcase. As a final practical test, ensure th ...

Removal of the generator cover
Note This operation is described for an engine removed from the frame since all reassembly procedures are easier with the engine on the bench. Disconnect the connector (a) from the generator ...

Other materials:

High beam flash not working - start/stop lap function not working
Fault codes Dds: no fault code displayed. Dashboard: no fault code displayed. Wiring diagram Db dashboard connection, s high beam flash button. 7 Orange - o, 1 red/blue - r/b. Location of connections and components Location of left hand handlebar switchgear set connection. Pin ...

Engine torque settings
*Dynamic safety-critical point; tightening torque must be within nm +/-5%. Note For product specifications and symbols, refer to paragraph "product specifications" (sect. 1 - 2). ...

Reassembling the electrical components support
Check the presence of clips (1), (9) and (24) on the support (5). Check the presence of rubber pads (6) and (8) and of cable grommet (7). Check that the voltage regulator (3) and the solenoid starter (18) are in place on the support (5) with their wiring as shown. The horn (22) mus ...

2026 | www.dudiavel.com |