Ducati Diavel Service Manual: Maintenance operations
- Vehicle pre-delivery
- Scheduled maintenance chart
- Maintenance operations
- Check engine oil level
- Changing the engine oil and filter cartridge
- Checking valve clearances
- Spark plugs replacement
- Changing and cleaning the air filters
- Checking the coolant level
- Changing the coolant
- Changing the brake fluid
- Changing the clutch fluid
- Draining the clutch hydraulic circuit
- Filling the clutch circuit
- Adjusting the steering head bearings
- Adjusting the chain tension
- Checking brake pad wear and changing brake pads
- Adjusting the throttle cable
- Adjusting the clutch lever and front brake lever
- Adjusting the position of the gear change and rear brake pedals
- Adjusting the front fork
- Adjusting the rear shock absorber
Appropriate diagnosis tools
97900.0211 Dds (ducati diagnosis system) without cables
97900.0227 Power cable and diagnosis
97900.0222 Power cable and diagnosis 1060838 (measurement module)
97900.0218 Vacuum sens ...
Vehicle pre-delivery
Transport packaging integrity check (if required);
Removal from the transport packaging (if required);
Motorcycle integrity check;
Check of the supplied kit completeness (refer to the parts l ...
Other materials:
Removal of the clutch
Note
For clarity, the figures show the engine removed from the frame.
Undo the fixing screws (1) and remove the ring (2) and the springs (3) from
the pressure plate (4).
Slide the pressure plate (4) paying attention to the circlips (6).
Remove the clutch control pin (14) and the ...
Refitting the oil pump
If removed, apply specific threadlocker on the bushing (7) outer thread, and
screw it in the crankcase half, observing the
height.
Position the reference bushings (15) and the oil sealing o-rings (2) and (4)
according to the crankcase lubrication
channels.
Position the oil pump on th ...
Fuel pressure test
Note
The on-screen icons used during this procedure are explained in a table at
the end of this section.
Undo the screws (2) and remove the flange cover (1).
Remove one of the two pipes of the fuel system (3).
Use the fuel pressure pipe (4) part no. 590.1.189.1A by connecting one e ...