Ducati Diavel Service Manual: Instruments
- Dashboard
- Dashboard system
- Lcd unit functions
- Vehicle speed indicator
- Engine rpm indicator (rpm)
- Clock
- Coolant temperature
- Dashboard on tank
- Tft - parameter setting/display
- Total distance covered indicator: "odometer"
- Trip 1 meter
- Trip 2 meter
- Distance travelled on fuel reserve: trip fuel
- Indicator cons. Avg - average fuel consumption
- Indicator cons. - Instantaneous fuel consumption
- Indicator speed avg - average speed
- Indicator trip time - trip time
- Indicator air - air temperature
- Engaged gear indicator
- Riding mode set indication
- Indication if the lap function is active/not active
- Riding style function (riding style change)
- Maintenance indicator
- First warning - oil service 1000 km
- Residual range indication when the service is due
- Indication of range reached for service
- Warning indication (alarms/signals)
- Low battery level
- Traction control (dtc) deactivated
- Hands free key (hf) not recognised
- Low hands free key (hf) battery level
- High engine coolant temperature
- Steering release error - steering still locked
- Dashboard diagnosis
- Setting menu
- Riding mode customisation
- Dtc (ducati traction control) setting function
- Tips on how to select the sensitivity level
- Engine setting function (engine power control)
- Default function (resetting ducati default parameters)
- Menu 2 on/off function
- Background setting function for the dashboard on tank - dashboard 1
- Backlighting setting function for the dashboard on handlebar - dashboard 2
- Digital rpm indication function
- Lap activation/deactivation function (lap time)
- Lap registration function
- Stored lap display function
- Stored lap erase function
- Battery voltage indicator (battery)
- Clock setting function
- Units of measurement modification function
- Abs disabling function
- Immobilizer override procedure
- Pin code change function
Checking the fuses
The main fuse box (1) and the secondary one (2) are located in the tool tray;
to reach the fuse box remove the seat as
specified under sect. 5 - 3 "Removal of the seat".
The fuses are accessed b ...
Dashboard
Note
The dashboard is supplied as a single component; its internal components
cannot be renewed separately.
Important
Whenever the dashboard is renewed, the ignition key programming procedure
m ...
Other materials:
Removing the timing belt driveshaft pulleys
Use the tool code 88713.1805 To hold the driving pulley on the engine
crankcase against rotation.
Important
If this operation is carried out with the engine installed in the frame,
hold the driveshaft pulleys against rotation using the
tool code 88713.2011 Mounted on the alternator cover.
Lo ...
Refitting the clutch transmission unit
Position pipe (4) on the clutch slave cylinder (r).
Position the two seals (19) and tighten the screw (18) to a torque of 23 nm +/-
10% (sect. 3 - 3, Frame torque settings).
Refit the bleed valve (17) and the dust gaiter (16).
To position the pipe retaining clamps (4) refer to the table on ...
Removal of the camshafts
Unscrew and remove the screws (7) and the o-rings (8) from the cylinder head
covers.
Remove the cylinder head cover (6).
Remove the gaskets (4) and (9).
Repeat the same procedure for the other cylinder head cover. Unscrew the
screws (3) securing the camshaft supports.
Withdra ...